Grundfos Holding A S HWRREP Hot Water Recirculation System User Manual Manual

Grundfos Holding A/S Hot Water Recirculation System Manual

Manual

Page 1 Page 2 Page 3 Page 4 Page 5 Page 6English (US)Installation and operatinginstructionsTable of contents1. Location 22. Installing the product 33. Control functions 44. Approvals 45. Fault nding 66. Technical data 87. Disposing of the product 91. LocationThis repeater is only for use with the ALPHA 15-55 HWR-D system and is intended for indoor installation only in areas safe from droplets and splashes.For optimum use, place the repeater between the ALPHA 15-55 HWR-D pump and the push-button located furthest away from the pump.2. Installing the productTo install the repeater:1. Connect the included USB cable to the repeater.2. Connect the other end of the USB cable to the included power adapter.3. Fit the included plug adapter to the power adapter.4. Plug the power adapter into a power outlet to power on the repeater.5. The LED on the repeater will light green to indicate the repeater is in operation.3. Control functionsThe repeater LED lights green when the repeater is in operation.4. ApprovalsFCC sectionsSection 15.19 (a) 3This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Section 15.21Any changes or modica-tions to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.Section 15.105 (b)This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accord-ance with the instructions, may cause harmful interfer-ence to radio communica-tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-ence to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.be think innovate99475028 0119ECM: 1251564- Connect the equipment to an outlet on a circuit dier-ent from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV techni-cian for help.This equipment should be installed and operated keep-ing the radiator at least 8 in (20 cm) or more away from person’s body.Canadian ISED informationThis equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules.Cet équipement est conforme aux limites 99475028_0119_Repeater_HWR-D.indd 1-7 1/23/2019 3:25:49 PM
Page 8 Page 9 Page 10 Page 11 Page 12d’exposition aux rayonne-ment dénies par la norme FCC / IC pour un environne-ment non contrôlé et est conforme aux directives d’exposition de la FCC en matière de radiofréquences et la norme RSS-102, des règles d’exposition aux radiofréquences (RF) de l’IC. Cet équipement doit être installé et utilisé en mainten-ant le radiateur à au moins 8 in (20 cm) du corps de la personne.This device (Repeater HWR-D) contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic De-velopment Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1.This device may not cause interference. 2.This device must accept any interference, including interference that may cause undesired operation of the device. Innovation, Science and Economic Development Canada ICES-003 Compli-ance Label: CAN ICES-3(B)/NMB-3(B).L’émetteur/récepteur exempt de licence contenu dans le présent appareil est con-forme aux CNR d’Innovation, Sciences et Développe-ment économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée auxdeux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscep-U.S.A.GRUNDFOS Americas Corp.9300 Loiret BoulevardLenexa, Kansas 66219Phone: +1 913 227 3400Telefax: +1 913 227 3500CanadaGRUNDFOS Canada Inc.2941 Brighton RoadOakville, OntarioL6H 6C9Phone: +1 905 829 9533Telefax: +1 905 829 9512MexicoBombas GRUNDFOS de MéxicoS.A. de C.V.Boulevard TLC No. 15Parque Industrial Stiva AeropuertoApodaca, N.L. 66600Phone: +52-81-8144 4000Telefax: +52-81-8144 4010GRUNDFOS INSTRUCTIONSRepeater HWR-DInstallation and operating instructions tible d’encompromettre le fonctionnement. Étiquette de conformité à la NMB-003 d’Innovation, Sciences et Développement économique Canada : CAN ICES-3(B)/-3(B). This device (Repeater HWR-D) complies with Industry Canada RSS-247 and license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, in-cluding interference that may cause undesired operation of the device.Ce dispositif est conforme à lanorme CNR-247 d’Industrie Canada ap-plicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit acceptertout brouillage reçu, y compris un brouillag e susceptible de provoquer un fonctionne-ment indésirable.5. Fault ndingIf the range for the push-button is not improved by installing the repeater, relocate the repeater within the house for optimum range of wireless signals.6. Technical dataAmbient temperature:34 to 104 °F (1 to 40 °C)Supply voltage for repeater with USB plug: 5 V DC +/- 10%Supply voltage for AC power adapter for the repeater:100-240 V AC +/- 10%, 50-60 Hz7. Disposing of the productThis product or parts of it must be disposed of in an environmentally sound way: 1. Use the public or private waste collection service.2. If this is not possible, contact the nearest Grundfos representative. See also end-of-life information at www.grundfos.com/product-recycling99475028_0119_Repeater_HWR-D.indd 8-14 1/23/2019 3:25:51 PM

Navigation menu