Gibson Innovations BT50 Wireless Portable Speaker User Manual 606780 printLow

Gibson Innovations Limited Wireless Portable Speaker 606780 printLow

User Manual

www.philips.com/supportUser manualAlways there to help youRegister your product and get support atQuestion?Contact Philips
1ENContents1 Important 2Important safety instructions 22 Your portable speaker 3Introduction 3What's in the box 3Overview of the speaker 33 Get started 4Charge the built-in battery 4Turn on/off 44 Play from Bluetooth devices 5Connect a device 5Disconnect a device 5Reconnect a device 65 Play from external devices 76 Product information 8 Speaker 8Bluetooth 8General information 87 Troubleshooting 9General 9About Bluetooth device 98 Notice 10Care of the environment 10Trademark notice 11
2EN1 ImportantWarning  Never remove the casing of this speaker.  Never lubricate any part of this speaker.  Never place this speaker on other electrical equipment.  Keep this speaker away from direct sunlight, naked Important safety instructionsa Read these instructions.b Keep these instructions.c Heed all warnings.d Follow all instructions.e Do not use this apparatus near water.f Clean only with dry cloth.g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.h Do not install near any heat sources such as radiators, heat registers, stoves, or produce heat. i Only use attachments/accessories j personnel. Servicing is required when the apparatus has been damaged in any way, such as liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.k Battery shall not be exposed to excessive l Apparatus shall not be exposed to dripping or splashing. m Do not place any sources of danger on Note  The type plate is located on the bottom of the apparatus.
3EN2 Your portable speakerCongratulations on your purchase, and support that Philips offers, register your product at www.philips.com/welcome.IntroductionWith this speaker, you can enjoy audio from Bluetooth-enabled devices or other external devices.What's in the boxCheck and identify the contents of your package: Speaker USB cable for charging Short user manualOverview of the speaker a LED indicatorabc de Indicate battery or Bluetooth connection status.b Source selector (OFF/AUDIO IN/  Select Bluetooth or AUDIO IN source.  Turn the speaker off.c PAIRING Enter Bluetooth pairing mode. Disconnect Bluetooth connection. d DC IN Recharge the built-in battery.e AUDIO IN Connect an external audio device.
4EN3 Get startedAlways follow the instructions in this chapter in sequence.Charge the built-in batteryThe speaker is powered by a built-in rechargeable battery.Note  Before use, fully charge the built-in battery.  The micro USB socket is for charging only.  It takes you approximately two hours to fully charge the battery.  Rechargeable battery has a limited number of charge cycles. Battery life and number of charge cycles vary by use and settings. Connect the USB cable between the DC IN socket on the speaker, and a USB socket on a computer. The LED indicator indicates the battery status.Under charging Fully charged"OFF" modeFlashing white Off"AUDIO IN" modeFlashing white Solid white"Bluetooth" modeFlashing blue or solid blue (depending on Bluetooth connection status)Flashing blue or solid blue (depending on Bluetooth connection status)Turn on/off To turn the speaker on, slide the source selector to AUDIO IN or .  To turn the speaker off, slide the source selector to OFF.Switch to standby modeThe speaker switches to standby mode automatically in the following situations: In Bluetooth mode, the connection with Bluetooth device is invalid for 15 minutes; or In AUDIO IN mode, no audio input cable is connected for 15 minutes.
5EN4 Play from Bluetooth devicesWith this speaker, you can listen to audio from Bluetooth-enabled devices.Note  The speaker can memorize a maximum of four paired   Any obstacle between this speaker and a Bluetooth device can reduce the operational range.  Keep away from any other electronic device that may cause interference.  The operational range between this speaker and a Bluetooth device is approximately 10 meters (30 feet).  Make sure that no audio input cable is connected to the AUDIO IN socket.Connect a device1 Slide the source selector to . »  2 On your Bluetooth device, enable Bluetooth and search for Bluetooth devices that can be paired (refer to the user manual of the device).3 Select [Philips BT50] displayed on your device for pairing and connection. If necessary, input “0000” as the pairing password. » After successful pairing and connection, the speaker beeps twice, and the LED indicator turns solid blue. [Philips BT50] on your device, press and hold PAIRING for more than three seconds until you hear triple beeps.4 Play audio on the Bluetooth device.Tip  You can use your Bluetooth device to control play.Indicator Bluetooth connection statusFast (2Hz)PairingSlow (1Hz)ConnectingSolid blue ConnectedDisconnect a device Press and hold PAIRING for more than three seconds; » The speaker beeps for three times. Disable Bluetooth on your device; or Move the device beyond the communication range. » The speaker beeps twice, and the LED 
6ENNote  Before connecting another Bluetooth device, disconnect Reconnect a deviceWhen you turn on the speaker, it will reconnect the last connected device automatically; If not, select [Philips BT50] on your Bluetooth device to start connection.
7EN5 Play from external devicesWith this speaker, you can also listen to an external audio device such as an MP3 player.Note  Make sure that music playback through Bluetooth is stopped. 1 Connect an audio input cable (not supplied) with a 3.5 mm connector on both ends to the AUDIO IN socket on this speaker, and the headphone socket on the external device.2 Slide the source selector to AUDIO IN. » The LED indicator turns white.3 Play audio on the external device (refer to its user manual).
8EN6 Product informationNote  Product information is subject to change without prior notice.Rated Output Power 1.5W RMSFrequency Response 100 -16000 Hz, ±3dBSignal to Noise Ratio > 70 dBAAudio-in Input 300 mV RMSSpeakerSpeaker Impedance 4 ohmSpeaker Driver 4cm full rangeSensitivity >82dB/m/W± 3dB/m/WBluetoothBluetooth Version V2.1 + EDR A2DPBluetooth Frequency Brand 2.4GHz ~ 2.48GHzBluetooth Range 10 m (Free space)General informationPower Supply (through micro USB socket)5 V, 0.5 ABuilt-in Li-polymer Battery 3.7 V, 365 mAhDimensions - Main Unit (W x H x D)61 x 76 x 61 mmWeight - Main Unit 0.1 kg
9EN7 TroubleshootingWarning  Never remove the casing of this device.To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.GeneralNo power Recharge your speaker.No sound Adjust volume on the connected device. When you listen to audio through Bluetooth, make sure that no audio input cable is connected to the AUDIO IN socket. Make sure that your Bluetooth device is within the effective operational range.No response from the speaker Recharge the speaker.About Bluetooth deviceThe audio quality is poor after connection with a Bluetooth-enabled device. The Bluetooth reception is poor. Move the device closer to this product or remove any obstacle between them.pairing. Press and hold PAIRING for more than three seconds, and then try again.Cannot connect with the device. The Bluetooth function of the device is not enabled. Refer to the user manual of the device for how to enable the function. This product is already connected with another Bluetooth-enabled device. Disconnect that device and then try again.The paired device connects and disconnects constantly. The Bluetooth reception is poor. Move the device closer to this product or remove any obstacle between them. For some devices, Bluetooth connection may be deactivated automatically as a power-saving feature. This does not indicate any malfunction of this product.
10 EN8 Noticedevice that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Notice for the USA and CanadaThis device complies with Part 15 of the FCC Rules and license-exempt RSS standard of Industry Canada. Operation is subject to the following two conditions: 1 this device may not cause harmful interference, and2 this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Relocate the receiving antenna. Increase the separation between equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.RF Radiation Exposure Statement: This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must be installed and operated to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. Installers must ensure that 20cm separation distance will be maintained between the device (excluding its handset) and users.Care of the environmentDisposal of your old product and battery Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or visit www.recycle.philips.com.This product contains non-removable batteries: Do not incinerate. Batteries may explode if overheated. For disposal or recycling information, please contact your local authorities or visit www.recycle.philips.com.Caution  Removal of the built-in battery invalidates the warranty and may destroy the product.Always bring your product to a professional to remove the built-in battery.
11EN Environmental informationAll unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.Trademark notice The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by WOOX Innovations is under license.
2015 © WOOX Innovations Limited. All rights reserved.Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.000000000000

Navigation menu