Franklin Technology R872 Mobile Hotspot User Manual statement

Franklin Technology Inc. Mobile Hotspot statement

Contents

User Manual(statement)

 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  (1)  This  device  may  not  cause  harmful  interference,  and  (2)  this  device  must accept any interference received, including interference that may cause undesired operation. This  equipment has been tested and found to comply with the limits for a Class B digital device,  pursuant  to  Part  15  of  the  FCC  Rules.    These  limits  are  designed  to  provide reasonable protection against harmful interference in a residential installation. This equipment generates,  uses  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in accordance with the instructions, may cause harmful interference to radio communications.   However, there is no guarantee that interference will not occur in a particular installation.    If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:   Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.  FCC Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for compliance could void the user's authority to operate this equipment.  This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any  other antenna or transmitter.
Radiation Exposure Statement: This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio  frequency  (RF)  energy  set  by  the  Federal  Communications  Commission  of  the  U.S. Government. The  exposure  standard  for  wireless  device  employs  a  unit  of  measurement  known  as  the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are  conducted  using  standard  operating  positions  accepted  by  the  FCC  with  the  device transmitting at its highest certified power level in all tested frequency bands.  Note: The  country code  selection is  for non-US  model only and is  not available  to all  US model.  Per  FCC regulation,  all  WiFi  product  marketed  in  US  must  fixed  to  US  operation channels only.

Navigation menu