Flir BelgiumBA CCTR Low-power (unlicensed) wireless device for leisure User Manual

Raymarine UK Ltd. Low-power (unlicensed) wireless device for leisure

Gseries Command Center

G-Series Command Center KeyboardInstallation instructionsWaste Electrical and Electronic Equipment DirectiveThe Waste Electrical and Electronic Equipment (WEEE) Directive requiresthe recycling of waste electrical and electronic equipment. Whilst the WEEEDirective does not apply to some of Raymarine’s products, we support itspolicy and ask you to be aware of how to dispose of this product.The crossed out wheelie bin symbol, illustrated above, and found on ourproducts signifies that this product should not be disposed of in generalwaste or landfill.Please contact your local dealer, national distributor or Raymarine TechnicalServices for information on product disposal. DisclaimerThe technical and graphical information contained in this document, to the best of ourknowledge, was correct as it went to press. However, our policy of continuous improve-ment and updating may change product specifications without prior notice. As a result,unavoidable differences between the product and handbook may occur from time totime. Raymarine cannot accept responsibility for any inaccuracies or omissions it maycontain. For the latest product information visit our website - www.raymarine.comEMC installation guidelinesRaymarine equipment and accessories conform to the appropriate ElectromagneticCompatibility (EMC) regulations. This minimizes electromagnetic interference betweenequipment, which could otherwise affect the performance of your system.Correct installation is required to ensure that EMC performance is not compromised.For optimum EMC performance, we recommend that:Raymarine equipment and the cables connected to it are:i. At least 3 ft. (1 m) from any equipment transmitting or cables carrying radio signals e.g. VHF radios, cables and antennas. In the case of SSB radios, the distance should be increased to 7 ft. (2 m).ii. More than 7 ft. (2 m) from the path of a radar beam. A radar beam can normally be assumed to spread 20 degrees above and below the radiating element.• Raymarine specified cables are used.• Cables are not cut or extended.Always allow the maximum separation possible between different items of electricalequipment. This will provide the best conditions for EMC performance for theinstallation.Technical specificationProduct installationThis equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in poor product performance, personal injury, and/or damage to your boat.Service and MaintenanceThis product contains no user serviceable components. Please refer all maintenance and repair to authorized Raymarine dealers.Unauthorized repair may affect your warranty.Ultra violet lightTo provide protection against the damaging effects of ultra violet (UV) light, the sun cover should be placed on the unit when not in use.CleaningDO NOT use acid, ammonia based or abrasive products.DO NOT use commercial high pressure washing (jet wash) equipment.Document number: 87084-1Date: July 2007Approvals:CE - conforms toFCC- conforms toAdditional conformanceEN60945, EN300-440-2CFR47 PART 15IC-RSS-210Size 297 x 98 x 46Weight 0.65 kgMounting Dash mountHandheld (with optional wireless upgrade)Supply voltage 9 V to 16 VPower consumption 1.5 WEnvironmental conditions: operating temperature: -15°C to 55°C (5°F to 131°F)non-operating temperature: -25°C to 70°C (-13°F to158°F)relative humidity limit: 95%water protection:waterproof to CFR-46 standardStorage conditions whenpacked: Temperature : -25°C to 55°C (-13°F to 158°F)relatiive humidity: 75%LEN 3Raymarine plcAnchorage Park,Portsmouth,Hampshire PO3 5TDUnited KingdomTel: +44 (0) 23 9269 3611Fax: +44 (0) 23 9269 4642Raymarine Inc.21 Manchester Street,Merrimack,New Hampshire 03054-4801USATel: +1 603.881.5200Fax: +1 603.864.4576www.raymarine.com
Pack itemsG-Series systemThe Keyboard is installed as a part of the Raymarine G-Seriesmarine electronics system.Refer to the additional documentation supplied with your G-seriesGPM400 processor for additional information necessary to installthe keyboard within your system.All documents can be downloaded fromwww.raymarine.com/handbooks.G-Series SystemMaximum quantity of KeyboardsThe G-Series system will support up to 8 keyboards.G-Series system documentationD10065-1SuncoverHandbook/DocumentationCommandcenter keyboardPanel sealStud (x4)Fingernut (x4)Rear clampassemblySeaTalkng backbone cableSeaTalkng spur cableSeaTalkng T connectorDescription Part No.G-Series command center keyboard E02044Sun cover R083071 m (3.3 ft) SeaTalkng/NMEA2000 cable A06039400 mm (15.75 in) SeaTalkng backbone cable A06033SeaTalkng T-piece connector A06028Rear cover / mounting bracket R08308Screw pack R08309Installation sheet 87084Warranty booklet 80017Title Part numberG-Series system installation and commissioning Instructions87070G- Series system operating guide 86126G-Series system user reference guide 81276MonitorKeyboardD10068-1SeaTalkng backboneSeaTalkng spurSeaTalkng spurGPM 4009WXYZ8TUV7PQRS4GHI5JKL6MNOACTIVEWPTSMOBDATAMENUPAGE.02ABC3DEF1CANCELSTANDBYDODGE PILOT OKRANGEOUTINENTER
Keyboard connectionsThe G-Series Keyboard communicates using the SeaTalkng system. It may be connected directly to the backbone (wired) or used remotely with a separate basestation and wireless upgrade kit.Note: You should have at least one permanently wired keyboard. In the event that any wireless keyboards are lost, the wired keyboard can be used to control the system.Schematic diagramWhen connecting a keyboard to the system, record its details on your system/schematic diagram. You will need this information dur-ing commissioning. (Refer to the separate G-Series system installation instructions for sample diagrams.)Keyboard connection details Keyboard cablesORSeaTalkng instrument, e.g. ST70SeaTalkngspurSeaTalkngspurKeyboardSeaTalkng backboneD10070-1Cable Part Number NotesKeyboard to SeaTalkng400 mm (15.75 in) SeaTalkng spur cableA060381 m (3.3 ft)SeaTalkng spur cable*A06039*Suppled with the keyboard3 m (9.8 ft)SeaTalkng spur cableA060405 m (16.4 ft)SeaTalkng spur cableA06041
Mounting arrangement Dimensions Mounting and environment• The keyboard is suitable for mounting both above and below decks. It is waterproof to CFR-46 standard.• Use the cutting template provided within this booklet.• Connect cable into keyboard before clamping in place.The following conditions apply:• Do NOT install near sources of heat. (e.g. engine).• Install the unit well away from potential sources of ignition.Cables• Minimum bend radius of 100 mm (3.94 in).D10101-1G-Series keyboardSun coverKeyboardPanel seal(adhesiveside up)SeaTalk NGcableStud (x4)Fingernut (x4)Rear clampassemblyD10226-1297 mm (11.69 in)98 mm (3.85 in) 35 mm (1.38 in) 59.8 mm (2.35 in) minimum clearance 46 mm (1.81 in)
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------11.1 in (281.6 mm)3.25 in (82.6 mm)Command Centre KeyboardTemplateRemove material from shaded area onlyInstrument edge Sun cover edgeDrill hole,19/64 in (7.5 mm) diameter in2 positionsDrill hole,15/16 in (23.6 mm) diameter in2 positionsD10143-1

Navigation menu