Firetide 3500-1 HotPort 3500-2401 User Manual Ubiquiti Users Manual

Firetide Inc. HotPort 3500-2401 Ubiquiti Users Manual

Contents

Ubiquiti Users Manual

SR2 MANUALThe SR2 hi-power mini-PCI 802.11b/g radio card module has been specifically designed for use in outdoor wireless applications where additional link gain is critical. It is compatible with existing Atheros linux drivers and is capable of operation in the 2412-2462 MHz frequency range. Power and frequency limits are hard programmed into the radio card EEPROM, but card compatibility can be achieved with any Atheros Linux based software. Many SBC host platforms have been qualified for use with the SR2 module including:-Mikrotik Router Boards-PC Engines WRAP boards-Many SBC platforms from large telecommunication companiesIt is necessary that the system integrators perform all applicable retesting and certification for their final system configurations.EXAMPLE OEM SYSTEM USAGEMODULAR USAGEPC ENGINES WRAP Wireless Router BoardATHEROS PUBLIC MADWIFI DriverUbiquiti Networks, Inc.778 N. First St.San Jose, CA 95112(408)-385-1103SR2Pac Wireless Roo TennaAntenna/EnclosureSoftware Driver
SR2 IMPORTANT MODULAR APPROVAL INFORMATIONThis device is intended only form OEM integrator under the following conditions: 1) The antenna must be installed such that 20cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. End Product Labeling This transmitter module is authorized only for use in devices where the antenna may be installed such that 20 cm may be maintained between the antenna and users (for example access points, routers, wireless ADSL modems, and similar equipment). The final end product must be labeled in visible area with the following: “Contains TX FCC ID SWX-SR2: End Product Manual Information The user manual for end users must include the following information in a prominent location “IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”
SR2 IMPORTANT OPERATION INFORMATIONSafety Information20 cm

Navigation menu