Echo Toys 91229R49 49 MHz Radio Receiver User Manual 91229LA new format info ai

Echo Toys Ltd 49 MHz Radio Receiver 91229LA new format info ai

users manual

   - Pressto move forward.Release to stop.   - Pressto move forward.Release to stop.JIMMY NEUTROU ULTRA ORB OWNER'S MANUALand    -Press at the same time to turn right spinning.and    -Press at the same time to turn left spinning.INTRODUCTIONYour Echo Jimmy Genius Ultra Orb is an all-terrain toy vehicle. It has two big wheels extending over the top of it, allowing it to travel in any direction you choose and perform many exciting stunts. Built to 1/14 scale, it reaches speeds up to 400 feet per minute.The Ultra Orb comes in two frequencies (27 MHz & 49 MHz). You can race with a friend, provided your Ultra Orbs operate on different frequencies. INSTALLING BATTERIESHaving a parent or adult to help your install batteries in your Ultra Orb is strongly recommended.Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.Cautions:• Use only fresh batteries of the required size and   recommended type.• Do not mix old and new batteries, different types of   batteries (standard, alkaline, or rechargeable), or   rechargeable batteries of different capacities.• If you do not plan to use the Ultra Orb for several days,   remove the batteries. Batteries can leak chemicals that   can destroy electronic parts.• Never leave dead or weak batteries in the Ultra Orb and   transmitter.A) TRANSMITTERThe transmitter requires one 9V battery (not included) for power. 1. Slide ON/OFF on the transmitter to OFF.2. Slide the battery compartment cover in the direction of the     arrow to remove it .3. Place the 9V battery in the compartment according to the     polarity symbols (+ and -) marked inside.4. Replace the cover and snap it shut.When the range of your transmitter decreases, replace its battery.B) THE ULTRA ORBYour Ultra Orb uses a 9.6V Ni-Cd rechargeable battery pack (not included) for power. Before using the battery pack, you must charge it.1. Slide ON/OFF switch on the bottom of the Ultra Orb to OFF.2. Use a coin to turn the battery compartment cover's latches     in the direction of the arrows until they stop, then remove     the cover.3. Attach the battery pack's white plastic connector to the     Ultra Orb's matching connector. Do not force them     together. They only fit one way. Carefully tuck the wire into     the compartment recess and place the battery pack into     the compartment.4. Replace the cover, making sure not to pinch the wires.     Then secure the latches with a coin.5. When the Ultra Orb stops operating properly, recharge the     battery pack.BATTERY CHARGINGNote: Follow the instruction on your 9.6V rechargeable Ni-Cd battery pack and charger system.• The 9.6V rechargeable Ni-Cd battery pack must be charged    prior to use.• When charging Ni-Cd battery pack, plug charger into    household outlet. Connect the charger with the Ni-Cd    battery pack.• Four hours is all that is required for a fully charged battery    pack. Charging the battery pack for more than 4 hours will    not give you the longer running time.• After use, the battery pack will be hot. Wait at least 10 minutes until the battery pack cools down before charging. Recharging a hot battery pack will greatly reduce the recharging life of your battery pack.DRIVING THE ULTRA ORB1. Insert the two supplied outriggers into the holes on each     side of the Ultra Orb with the outriggers curved upwards.2. Slide ON/OFF on the bottom of the Ultra Orb to ON.3. Slide ON/OFF on the transmitter to ON.4. Use the transmitter's control buttons to control the     movement and direction of the Ultra Orb.5. When you finish driving, slide ON/OFF on both the Ultra     Orb and the transmitter to OFF.EXPERT SKILLSWhen the Ultra Orb leans to either side and you are riding on the outriggers, press either     or     to drive upright again.While moving forward, quickly release Left and Right     and press Left and Right     . The Ultra Orb rolls over!While driving upside down:• Hold down      to move backwards in a rocking motion.• Hold down      to move forward in a rocking motion.NOTE: While driving upside down, the buttons become opposite of their original function. For example, causes the Ultra Orb to move backward, and spin left causes it to spin right.Warnings:• Never play with the Ultra Orb in the street.• Be careful to avoid collisions with people and objects.• Don't touch the wheels when you turn on the Ultra Orb. This   can cause injury.HELPFUL HINTS• Running your Ultra Orb continuously for long periods   generates high heat levels. Heat causes wear and tear on   the motor. To help keep heat levels down, when your Ultra   Orb's battery pack dies, let the Ultra Orb cool at least 10   minutes before installing a new or newly charged battery   pack.• If someone uses a CB nearby, it might interfere with control   of the Ultra Orb. If this happens, move the Ultra Orb away   from the CB.• You cannot operate your Ultra Orb near devices with   transmitters that use the same frequency as your Ultra Orb   (27 MHz or 49 MHz). Check your Ultra Orb' s box to see   which frequency your Ultra Orb uses.• If the Ultra Orb moves slowly and you just installed a fully   charged battery pack, check the wheel mechanisms for lint,   thread, hair, or dust.CARE• Do not drive the Ultra Orb through puddles or mud, on a   wet floor, or in sand, rain, or snow. These can damage it .• Do not expose the Ultra Orb or transmitter to temperature   extremes, and do not store them in direct sunlight or near a   heat source.• Do not leave the Ultra Orb or transmitter outside overnight.   Night dampness can damage their electronic circuits.• To protect the Ultra Orb's mechanisms from lint and hair, do   not drive the car on carpet.• Wipe the Ultra Orb and transmitter with a damp cloth   occasionally to keep them looking new. Do not use harsh   chemicals to clean them.THE FCC WANTS YOU TO KNOWNOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the User's authority to operate the equipment.Modifying or tampering with the Ultra Orb or transmitter's internal components can cause a malfunction and void your FCC authorization to operate it.JIMMY NEUTROU ULTRA ORB ON/OFF SWITCH9.6V Ni-Cd or NiMH rechargeable battery pack  110Vchargeroutriggers OPENOPENOPEN OPENCLOSECLOSE CLOSE9.6V Ni-Cd or rechargeable battery packON/OFF SWITCHbattery cover   - Pressto move forward.Release to stop.   - Pressto move forward.Release to stop.ON/OFFSwitchOWNER'S MANUAL© 2003 ECHO TOYS LTD. ALL RIGHTS RESERVED. ROOM 1108, PENINSULA CENTRE, 67 MODY ROAD,TSIM SHA TSUI EAST, KOWLOON, HONG KONG.WEB SITE: http://www.echotoys.com.hkITEM:91229PRINTED IN CHINA

Navigation menu