Dr ger Safety and KGaA FPSCOM7000 Firefighting Communication System User Manual 1902717463

Dräger Safety AG & Co. KGaA Firefighting Communication System 1902717463

user manual annex

Material / Werkstoff Modification Text / Änderungstext Amends / Kommt vor 0X Scale / Maßstab General Tolerance / Allgemeintoleranzen =EX= =QS= =QF= Registration/ Ser.Type / Ser.art Docum. / Erf.beleg Doc.Type / Dok.art Total SL(tA) / Ges.halt. Min.u.time(tG) / Min.n.d --- --- --- No/Nein No/Nein Created by/ Bearbeitung Date / Datum (dd.mm.yyyy) Checked by / Verantwortlich Date / Datum (dd.mm.yyyy)Department / Abteilung Skrabs S 17.12.2015 Rüffert L 17.12.2015 st5430 Description / Benennung DCC Number / Nummer Status / Reifegrad FPS-COM 7000 Extract IFU FPS-COM 7000 Extract IFU / / PrepPart No. / Sachnummer – Rev / ÄZ Appr./Zul.SE23682 - 00 Y Document Type / Dokumententyp TEXT_DRAWING A4 Page / Seite 1 of / von 2 Repl. for / Ersatz für Schutzvermerk ISO 16016 beachten. Use of this document / contents is forbidden without expressed written authority. All rights reserved. Dräger Safety Extract from Instruction for Use for FPS-COM 7000 (technical segment: “radio”, “EMC”) Europe (EU): EU Declaration of Conformity (accompanied by a copy of the EU declaration of conformity) HINWEIS Die abgebildeten Geräteaufkleber sind nur Beispiele. Die jeweilige Klassifizierung ist auf dem Geräteaufkleber an der Kommunikationseinheit aufgeführt NOTICE The device labels shown are intended as an example only. The respective classification is indicated on the device label on the communication unit. Funkfrequenzen / Radio frequencies abgestarhlte Sendeleistung (ERP) / Effective radiated power (ERP) zugelassen in / Approved in 863 MHz ... 865 MHz (Teamfunk) / (Team radio) ≤ 10 dBm EU, TR, CY 915 MHz ... 928 MHz (Teamfunk) / (Team radio) ≤ 10 dBm AU, NZ 2402 MHz ... 2480 MHz (Bluetooth) ≤ 7 dBm EU, US, CA, AU, NZ 127 kHz (LFC) ≤ -50 dBm US, CA, AU, NZ on the label: “FPS COM 7000” “863-865MHz” Example: USA/Canada: “This device complies with Industry Canada licence-exempt RSS standard(s) and part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation.
Description / Benennung Status / Reifegrad FPS-COM 7000 Extract IFU FPS-COM 7000 Extract IFU PrepPart No. / Sachnummer – Rev / ÄZ Y SE23682 - 00 Document Type / Dokumententyp TEXT_DRAWING A4 Page / Seite 2 of / von 2 Repl. for / Ersatz für Schutzvermerk ISO 16016 beachten. Use of this document / contents is forbidden without expressed written authority. All rights reserved. Dräger Safety Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.” “EMC” related : “Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.” on the label, USA requirement: “FCC ID: X6O-FPSCOM7000” “902-928MHz” on the label, Canadian requirement: “IC: 5895F-FPSCOM7000” “902-928MHz” “EMC” related : “CAN ICES-3 (B) / NMB-3 (B)” Australia: on the label: “FPS COM 7000” “915-928MHz” Example:

Navigation menu