DENSO Korea FN00040 Smart key FOB User Manual ORIGINAL

DENSO KOREA ELECTRONICS CORPORATION Smart key FOB ORIGINAL

User manual

3. Outline of Smart Key FOBElectronic Key is mainly used for locking or unlocking the doors of the vehicles. Electronic Key detects signals when it reaches the vicinity of vehicle, and sends signals using radio frequency. Also, Electronic Key sends a radio wave signal while a button is pushed. When the button is released, the radio wave signal is automatically off within 0.392 seconds. When the button is depressed continuously, Electronic Key sends a signal for a predetermined constant time. This product sends a signal when the following buttons are pushed. Transmitter ICActuator Receiver Subject for applicationInstallation in vehicleMicom Electronic Key Control ICLF Transmitter 314.35 MHz 134.2 kHz Smart Key ECU Trunk button for opening the trunk or back door. Lock button for locking the doors Unlock button for unlocking the doors. Panic button for Panic Alarm
Electronic Key Product Outline Product Description Product Type FN00040 RF characteristic Nominal frequency 314.35MHz Oscillator frequency 18.370MHｚ X-tal, PLL synthesizer Antenna Built-in type (Fixed) Button 4-Button type Lock Unlock Trunk Panic Power Supply Nominal supply voltage 3V DC Type of Battery One lithium battery Electronic Key is mainly used for locking or unlocking the doors of the vehicle. Electronic Key detects signals when it reaches the vicinity of vehicle, and sends signals using radio frequency. Also, Electronic Key sends a radio wave signal while a button is pushed. When the button is released, the radio wave signal is automatically off within 0.392 seconds. When the button is depressed continuously, Electronic Key sends a signal for a predetermined constant time. The receiver becomes active in response to signals from the transmitter. Unit: mm Appearance 4-Button type
Explanation document of mechanical key for Electronic Key FN00040 ・Key groove varies according to each key. ・The key used for testing has no groove on its surface, which we consider is a worst case. Presence or absence of mechanical key does not affect on the RF characteristics. Mechanical key detached Mechanical key attached Mechanical key
FCC ID: CQOFN00040FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. IC: 1151E-FN00040Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Navigation menu