Controlled Entry Distributors IV318W4K Remote Controller User Manual CC Firefly FIR3IV318LIP4K Manual

Controlled Entry Distributors, Inc. Remote Controller CC Firefly FIR3IV318LIP4K Manual

Users Manual

Black Case with four buttonsMade in Taiwan. Copywrite © 2015 Community Controls.The warranty period of Community Controls Firefly4™ transmitter is twenty-four (24) months. This warranty shall begin on the date the transmitter is manufactured. During the warranty period, the product will be repaired or replaced (at the sole discretion of Community Controls) if the product does not operate correctly due to a defective component. This warranty does not extend to (a) the transmitter case, which can be damaged by conditions outside the control of Community Controls, or (b) battery life of the transmitter. This warranty is further limited by the following disclaimer of warranty and liability:EXCEPT AS SET FORTH ABOVE, COMMUNITY CONTROLS MAKES NO WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF COMMUNITY CONTROLS, EXPRESS OR IMPLIED, WITH REGARD TO THE GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. COMMUNITY CONTROLS SELLS THE GOODS TO BUYER ON CONDITION THAT COMMUNITY CONTROLS WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER AGREES THAT COMMUNITY CONTROLS SHALL HAVE NO LIABILITY FOR DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO HOLD COMMUNITY CONTROLS HARMLESS FROM ANY CLAIMS BUYER, OR ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS TERMS IN CONSIDERATION OF RECEIVING THE GOODS.NOTICEAny changes or modifications to Community Controls equipment not expressly approved by Community Controls could void the manufacturer’s warranty and could void the user’s authority to operate the equipment.2500 South 3850 West, Suite ASalt Lake City, UT 84120(800) 284-2837(866) 867-3637 Faxwww.communitycontrols.com318 4 Btn Wiegand TX4Linear’s MegaCode® series of digital transmitters are wireless radio controls designed for use with MegaCode format receivers. The MegaCode radio format provides unparalleled security. Each transmitter is pre-set at the factory to one of over 1,000,000 codes. The 318-Wiegand TX is a four-button miniature transmitter that sends a unique code for each button. Typically, onebutton is used to operate a community access gate, another buttoncan activate an individual’s garage door, the other two buttons canactivate additional automatic doors or other devices. The transmitter is powered by one Type "27A 12V" batteries.Operating frequency : 318MHzNumber of buttons : 4Battery : 1 ea. 12V A27Operating temperature : -20°F - 85°FOverall dimensions : 2 x 1.5 x 1/2 inchWeight: 1 oz.2 - NUMBERING2 - NUMBERING1 - TRANSMITTER OVERVIEW3 - PROGRAMMING4 - OPERATION5 - BATTERY ACCESSTo access the battery, remove the set screw. Next, place a flat object such asa coin in the top corner notch of the case. Twist the object gently to open the case. Attend to proper polarity when installing or replacing the battery. Whencomplete, squeeze the top and back cover gently together until the case is completely closed, then replace and tighten the screw.NOTE: Please dispose of the batteries properly according to local laws and regulations. Test proper battery installation by verifying that the LED illuminates when the button is pushed.5 - BATTERY ACCESS3 - PROGRAMMINGEach transmitter is manufactured and sold with a different factory-set serial number.The transmitter must be programmed into your system memory. Your own installer or reseller will provide you the necessary instructions for your system.4 - OPERATIONA - Firmly depress the button until the small red LED illuminates.B - After the LED has illuminated, release the button. If the device you are attempting to activate does not respond, repeat steps A and B or consult section 7 ( Troubleshooting ) of this manual.6 - TROUBLESHOOTING6 - TROUBLESHOOTINGFaultThe system does not receive the transmitter signalThe transmitter led is OFFThe transmitter led is blinkingThe operating range is reducedThe system does not receive the transmitter signalThe transmitter led is ON . SolutionReplace the transmitter batteryCheck the power supply of the receiverCommunity Controls Firefly4TM Type: FIRlV318LI4K FCC ID: SU7IV318W4K12341234Screw

Navigation menu