Cisco Systems 102061 5GHz 802.11a MIMO Radio Module User Manual 125h b

Cisco Systems Inc 5GHz 802.11a MIMO Radio Module 125h b

Contents

Updated User Manual

B-1Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03APPENDIXBDeclarations of Conformity and Regulatory InformationThis appendix provides declarations of conformity and regulatory information for the Cisco Aironet 1250 Series Autonomous Access Point and the Cisco Aironet 1250 Series Lightweight Access Point. This appendix contains the following sections:•Manufacturers Federal Communication Commission Declaration of Conformity Statement, page B-2•VCCI Statement for Japan, page B-3•Industry Canada, page B-4•European Community, Switzerland, Norway, Iceland, and Liechtenstein, page B-4•Declaration of Conformity for RF Exposure, page B-7•Guidelines for Operating Cisco Aironet Access Points in Japan, page B-8•Administrative Rules for Cisco Aironet Access Points in Taiwan, page B-9•Operation of Cisco Aironet Access Points in Brazil, page B-12•Declaration of Conformity Statements, page B-13•Declaration of Conformity Statements for European Union Countries, page B-13
B-2Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationManufacturers Federal Communication Commission Declaration of Conformity StatementManufacturers Federal Communication Commission Declaration of Conformity StatementManufacturer:Cisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706USAThis device complies with Part 15 rules. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:•Reorient or relocate the receiving antenna.•Increase separation between the equipment and receiver.•Connect the equipment to an outlet on a circuit different from which the receiver is connected.•Consult the dealer or an experienced radio/TV technician.Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device.Models Certification NumbersAIR-RM1252A-A-K9 LDK102061AIR-RM1252G-A-K9 LDK102062Tested To ComplyWith FCC StandardsFOR HOME OR OFFICE USE
B-3Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationVCCI Statement for JapanCaution Within the 5.15 to 5.25 GHz and 5.47-5.725 GHz bands, this device is restricted to indoor operations to reduce any potential for harmful interference to co-channel Mobile Satellite System (MSS) operations.VCCI Statement for JapanWarningThis is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.
B-4Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationIndustry CanadaIndustry CanadaCanadian Compliance StatementThis Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du Canada.This device complies with Class B Limits of Industry Canada. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. This device must accept any interference received, including interference that may cause undesired operation.Cisco Aironet 2.4-GHz Access Points are certified to the requirements of RSS-210 for 2.4-GHz spread spectrum devices, and Cisco Aironet 54-Mbps, 5-GHz Access Points are certified to the requirements of RSS-210 for 5-GHz spread spectrum devices.The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.European Community, Switzerland, Norway, Iceland, and LiechtensteinModels:AIR-RM1252A-E-K9AIR-RM1252G-E-K9Certification Numbers2461B-1020612461B-102062
B-5Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationEuropean Community, Switzerland, Norway, Iceland, and LiechtensteinDeclaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
B-6Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationEuropean Community, Switzerland, Norway, Iceland, and LiechtensteinThis device complies with the EMC requirements (EN 60601-1-2) of the Medical Directive 93/42/EEC.For 2.4 GHz radios, the following standards were applied:•Radio: EN 300.328-1, EN 300.328-2•EMC: EN 301.489-1, EN 301.489-17•Safety: EN 60950-1Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.
B-7Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationDeclaration of Conformity for RF ExposureFor 54 Mbps, 5 GHz access points, the following standards were applied:•Radio: EN 301.893•EMC: EN 301.489-1, EN 301.489-17•Safety: EN 60950-1The following CE mark is affixed to the access point with a 2.4 GHz radio and a 54 Mbps, 5 GHz radio:Declaration of Conformity for RF ExposureThe radio has been found to be compliant to the requirements set forth in CFR 47 Sections 2.1091, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices as defined in Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields. The equipment shoud be installed more than 20 cm (7.9 in.) from your body or nearby persons.The access point must be installed to maintain a minimum 20 cm (7.9 in.) co-located separation distance from other FCC approved indoor/outdoor antennas used with the access point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access point. The access point’s co-located 2.4 GHz and 5 GHz integrated antennas support a minimum separation distance of8 cm (3.2 in.) and are compliant with the applicable FCC RF exposure limit when transmitting simultaneously.Note Dual antennas used for diversity operation are not considered co-located.
B-8Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationGuidelines for Operating Cisco Aironet Access Points in JapanGuidelines for Operating Cisco Aironet Access Points in JapanThis section provides guidelines for avoiding interference when operating Cisco Aironet access points in Japan. These guidelines are provided in both Japanese and English.Japanese TranslationEnglish TranslationThis equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and unlicensed specified low-power radio stations) used in factory production lines.1. Before using this equipment, make sure that no premises radio stations or specified low-power radio stations of RF-ID are used in the vicinity.2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the frequency or stop using the device; contact the number below and ask for recommendations on avoiding radio interference, such as setting partitions.3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the number below.Contact Number: 03-5549-650003-6434-650043768
B-9Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationAdministrative Rules for Cisco Aironet Access Points in TaiwanAdministrative Rules for Cisco Aironet Access Points in TaiwanThis section provides administrative rules for operatingCisco Aironet access points inTaiwan. The rules are provided in both Chinese and English.Access Points with IEEE 802.11a Radios Chinese TranslationEnglish TranslationThis equipment is limited for indoor use.
B-10Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationAdministrative Rules for Cisco Aironet Access Points in TaiwanAll Access PointsChinese TranslationEnglish TranslationAdministrative Rules for Low-power Radio-Frequency DevicesArticle 12For those low-power radio-frequency devices that have already received a type-approval, companies, business units or users should not change its frequencies, increase its power or change its original features and functions.Article 14The operation of the low-power radio-frequency devices is subject to the conditions that no harmful interference is caused to aviation safety and authorized radio station; and if interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.The authorized radio station means a radio-communication service operating in accordance with the Communication Act. The operation of the low-power radio-frequency devices is subject to the interference caused by the operation of an authorized radio station, by another intentional or unintentional radiator, by industrial, scientific and medical (ISM) equipment, or by an incidental radiator.
B-11Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationAdministrative Rules for Cisco Aironet Access Points in TaiwanChinese TranslationEnglish TranslationLow-power Radio-frequency Devices Technical Specifications4.7 Unlicensed National Information Infrastructure4.7.5 Within the 5.25-5.35 GHz band, U-NII devices will be restricted to indoor operations to reduce any potential for harmful interference to co-channel MSS operations.4.7.6 The U-NII devices shall accept any interference from legal communications and shall not interfere the legal communications. If interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.4.7.7 Manufacturers of U-NII devices are responsible for ensuring frequency stability such that an emission is maintained within the band of operation under all conditions of normal operation as specified in the user manual
B-12Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationOperation of Cisco Aironet Access Points in BrazilOperation of Cisco Aironet Access Points in BrazilThis section contains special information for operation of Cisco Aironet access points in Brazil.Access Point ModelsAIR-AP1252G-A-K9AIR-LAP1252G-A-K9AIR-RM1252G-A-K9Regulatory InformationFigure B-1 contains Brazil regulatory information for the AIR-AP1252G-A-K9, AIR-LAP1252G-A-K9, and the AIR-RM1252G-A-K9.Figure B-1 Brazil Regulatory InformationPortuguese TranslationEste equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.English TranslationThis equipment operates on a secondary basis and consequently must accept harmful interference, including interference from stations of the same kind. This equipment may not cause harmful interference to systems operating on a primary basis.
B-13Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationDeclaration of Conformity StatementsDeclaration of Conformity StatementsAll the Declaration of Conformity statements related to this product can be found at the following URL:http://www.ciscofax.comDeclaration of Conformity Statements for European Union CountriesThe Declaration of Conformity statement for the European Union countries is listed below:
B-14Cisco Aironet 1250 Series Access Point Hardware Installation GuideOL-8247-03Appendix B Declarations of Conformity and Regulatory InformationDeclaration of Conformity Statements for European Union Countries

Navigation menu