Chungear Co CE10710 Ceiling Fan Remote Controller (Transmitter) User Manual

Chungear Industrial Co Ltd Ceiling Fan Remote Controller (Transmitter)

User Manual

Model # TR190C+JY1055(with light function)DC POWER CEILING FAN REMOTE CONTROL MANUAL□INSTALLATION INSTRUCTIONSNOTE:This unit is to be used for the control of DC power ceilingfan and in an AC120V 60Hz power supply only. Output Power:40W(Max.)formotorand30W(Max.)forLEDlight.Important:Usingafullrangedimmerswitch(notincluded)tocontrolfanspeedwilldamagethefan.Toreducetheriskoffireorelectricalshock,donotuseafullrangedimmerswitchtocontrolfan speed.1.Switchpoweroffatfuseboxorcircuitbreakerbeforeyoubegin installing the fan.2.MakewiringconnectionsasindicatedFig.1.3.Launchdistanceforremotecontrol:about10m.4. The remote code setting process:Step: 1 Open the remote battery cover and install DC12V,A23 1pcalkaline battery, with the fan power off. (Fig. 2)Step: 2. Within 30 seconds of restring power to the fan, you must useaball pen or tool to press “Learn” button about 2 seconds. Oncethereceiver has detected the frequency, the ceiling fan light will turn on, then off.This will indicate the receiver has learned the frequency that waspreviouslyselected on the transmitter.Note: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing sowill cause the procedure to fail.After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is notresponding to the transmitter, please turn the power off to the receiver. And repeat step 2.If you want to clear before learned transmitter, hold the “Learn” button about 12 seconds. The ceiling fan light willflash twice.□FUCNCTIONS OF REMOTE CONTROL: (Fig. 3)The receiver will make bi sound when light is dim for the brightness ordarknesslevel.When the battery is low power, press any button and LED light would be flash about 2 seconds. Please changeand use new battery.Fig. 2Fig. 1TR190C
To assure continued FCC compliance:FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or more of the following measures:--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.--Consult the dealer or an experienced radio/TV technician for help.CAUTION:To assure continued FCC compliance:Any changes or modifications not expressly approved by the grantee of this device could void the user's authorityto operate the equipment.FCC ID：KUJCE10710This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.

Navigation menu