Chiayo Electronics Co SM-716 Wireless Microphone Transmitter User Manual

Chiayo Electronics Co Ltd Wireless Microphone Transmitter Users Manual

Users Manual

OPERATINGMANUALFITNESS AUDIO WIRELESS MIC SYSTEMU & V SeriesSDR-1716/DR-204 ReceiversSM-716/M-209C Transmitters
j..-{It .1i~~audIO~1. INTRODUCTIONCongratulations on your purchase of the state-of-the-art Fitness Audio PLL.Synthe-sized 16 channel frequency agile UHFhigh band or VHFprofessional wireless system.Please read this operating manual thoroughly in order to familiarizeyourself with thecontrols before using.2. FRONTAND REARPANEL CONTROLS1. Power Switch2. Power On Indicator3. RF Signal Indicator4. Diversity Indicator5. AF Signal Indicator6. RFTest Button7. Channel Selector (U-Series only)8. Volume Control9. Antenna B Socket10. Fixed Mic level 20mV11. Adjustable Line level 600mV12. Squelch (SO) Control13. DC INJack14. Antenna A SocketRFTESTTofindthe best channel for transmission (U-Seriesonly),ensure the receiver is con-nected to a mixer and amplifier and press the RFTestbutton (6).Ifinterference isheard select the next channel in order using switch (7)and repeat the test until aclean channel isfound. Then select the matching channel number on the Belt-PackTransmitter and test for voice level.3. BELT-PACKTRANSMITTERChannelSelectionand GainThe channel selector and gain adjustment are located under the battery cover a~shown in the picture below.To make channel selection (U-Seriesonly) remove t~cover and select a channel by turning the ChannelSelector(6)with a small screwcGain adjustment for Lavalierand Headset microphones can be done by adjusting IMTtrimpot(S),whereas GTtrimpot(4)isforthe gain adjustment of an ElectricGuitalor other high impedance line level inputs. Ifyou're using the Transmitter with anAeromic then turn down the MTtrimpot to minimum. Ifusing an E.Micor V.Mic.leave the MTtrimpot at full and turn down only ifdistortion is evident.Due to minor variations in the casing sizes of many brands of 9Vbatteries, thetransmitter battery compartment isdesigned to accommodate the preferred 9Vbattery made by Eveready - the Energiser 9VAlkaline-but other brands may alswork well. Re-chargeable Ni MH batteries @ 170-190mAH ratings may need to blrecharged after about 1.5-2.0 hours of continuous use, whereas Alkaline9VBatwillgenerally be suitable for about 6 - 8 hours of airtime with the Aeromic or E.rV.Micwireless microphones.~1. Battery Status Indicator2. Power Switch3. Microphone Connector4. GTTrimpot5. MTTrimpot6. Channel Selector (U-Seriesonl
.I 1-----ftitt$audio~Arange of transmitter Pouchbelts in different styles and colours which can be wornunder or over your clothes are available for many different users, including fitnessinstructors, actors, musicians and professional presenters. For more details pleaseconsult your FASystem supplier after visiting the two pouch belt pages at our website:http://wwwJitnessaudio.com.au/Pouchbelts shown L -R:Standard, Hipster, Zipster, Grey Zipster, Beige Theater belt.4. RECEIVERINSTAllATIONAudio output connectionThere are two audio outputs on the back of the U-&V-Seriesreceivers, a Mic-levelbalanced XLR-Mand Line-level unbalanced 6.3smm jack. Use shielded audio cablefor the connection between the receiver and the mixer.Ifthe mixer/amp. has a 6.3smm jack input socket, connect the supplied cable fromthe 6.3smm unbalanced output on the FAreceiver into this socket. Ifconnecting toan Aeromix 1+1EUMixeruse the unbalanced Jack to Jack cable for perfect matching.Thisaudio connection is shown below.r'I JtI1JJ!t1f$audidHowever, ifthe mixer has an XLRinput socket, then purchase a balanced XLR-Fto XLR-Mcable to connect the receiver to the MicInput. When connecting to anAeromix 2+2EUMixeror 2+2PM Powered Mixer,purchase a balanced cable XLRFemale to TRS(stereo)6.3smm Jack Plug for a perfect match and the best soundquality froman Aeromicor E.MicN.Mic.Boththe 2+2modelswill alsoaccept arunbalanced jack to jack lead connec tion with the Receiver'sOutput Volume Conadjusted downto suit.Abalancedcableconnectionwill givethe highestsoundpossible from any microphone with more "body" in the voice being the main aucdifference.5. RACKMOUNTINGFitness Audio U-&V-series are a 1/2 19"rack mount design and the speciallydesigned 19"rack mount adapter (MP-50)is available as an optional extra. Ablanfiller panel MP-12isalso available ifyou use just one receiver and, ifyou need tobring the antennas forward for technical reasons, the MP-12Apanel has Antennaextensions fitted.~1IForbest operation, the receiver should be at least 1m above the ground and at lE1m away from a wall or metal surface to minimize reflections as shown below. Keantennas away from RFnoise sources such as motors, automobiles, neon lights, cwell as large metal objects.The wireless mic user should also keep at least 1m away from a wallor metal surfto minimize reflections.
6. REMARKS1.RFInterferenceIf you encounter receivinginterference(fromotherthan an operatingTVstation),it can often be overcome by adjusting the receiver's squelch control, as describedbelow. Please note that wireless frequencies are shared with other radio services,andaccording to FCCregulations wireless microphone operations are unprotected frominterference from licensed operations in the band. Ifany interference is received byany Government or non-Government operation, the wireless microphone must ceaseoperation. (Theabove statement isvalid for the U.5.A.)2. Receiver Squelch controlThe squelch control on the back panel of the receiver is preset at the factory, but canbe adjusted ifyou must use the system in a high RFinterference area. Ifthere isaudiooutput from the receiver when your transmitter is OFF,adjust the squelch control sothe system willreceive the signal from your transmitter but squelch or eliminate theunwanted background RFnoise.Thisadjustment can cause a reduction in usable rangeoffhe wireless transmitter, so set the control to the lowest position which reliably,.mutes the unwanted RFsignal.3.BatteriesMany batteries are known to leak conductive and/or corrosive liquid when not usedfor a period of time. Please remove the batteries from the transmitter ifit is not to beused for a period of a few days or more..audiO'7. HANDMICSj~The Fitness Audio U-and V-seriesReceiversare compatible with certain modelChiayo hand held microphones. Formore information please consult your FitAudio supplier. Please note that you can only use one mic transmitter at a timEthe FASeries Receivers so make sure the Beltpack Transmitter is turned off bEusing a handmic transmitter.'1SQ-816 (U-Series compatiQ-209 (V-Series compatib1.Capsule with metal grille2. Battery Good Indicator (~3. Battery LowIndicator (rei4. Poweron/off switch5. Channel Switch6. Charging ContactsSQ-916 (U-Series only)1.Capsule with metal grille2. Battery indicator3. Sensitivity switch4. Poweron/off switch5. Channel Switch6. Battery cover7. Color cap
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution : To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
f?fif$audid'",~Warranty Information(Pleaseretain for your records)This product was purchased by:(YourBusiness) .............on (date) ..I ..I ..from (Company) ... .. ... ... .. .. ....of (address) """""""Model Number(s)..................................................Serial Number(s)...................................................Fitness Audio@Wireless Systems, Aeromic@,E.MicTM&V.MicTMHeadmicsand Aeromix@Audio Mixersare distributed worldwide exclusively by:Fitness Audio DistributorsEmail:info@fitnessaudio.com.auWebsite: wwwJitnessaudio.com.auFax:+61 2 9313 5569Manufactured forFitness Audio Network P/LPO Box321 Alexandria, NSW1435 AustraliaManufactured by (i)CHIAYOChiayo Electronics,30 Lane 27 Sec.4.Jen-AITaipei,Taiwan

Navigation menu