Chamberlain Group The 2281 Remote Control Transmitter User Manual 3264

Chamberlain Group Inc, The Remote Control Transmitter 3264

Exhibit D Users Manual per 2 1033 b3

To prevent possible SERIOUS INJURY or DEATH from amoving gate or garage door:• ALWAYS keep remote controls out of reach of children.NEVER permit children to operate, or play with remotecontrols.• Activate gate or door ONLY when it can be seen clearly, isproperly adjusted, and there are no obstructions to doortravel.• ALWAYS keep gate or garage door in sight until completelyclosed. NEVER permit anyone to cross path of moving gateor door.WARNINGCAUTION WARNINGWARNINGLocating your code switchesSlide the battery compartment cover back to access thecode switches in the remote control (Figure 1).+0–1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ONCode Switches (1-10)Model 300MCTo match or change the code in theremote controlLocate the code switches in both the new and the originalremote controls, either by removing the case screw andcover or by sliding the battery compartment cover back.Place remote controls side by side as shown (Figure 2)and set switches in all remote controls to matchingpositions (ON/OFF). Use a pen or screwdriver to slide thecode switches.Figure 1Match code switches (1-10)between old remote control and new remote controlMatch code switches (1-10)between old remote control and new remote controlMatch code switches (2-10)between old remote control and new remote control1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ONSingle-Button Remote ControlModel 300MC*For use with 300 MHz Multi-Code™ compatiblereceivers including Chamberlain Tri-Code Receivers.Figure 2*Multi-Code™ is the trademark of The Linear Corporation
© 2006 The Chamberlain Group, Inc.114A3264 All Rights ReservedMatch the remote control to thereceiver:1. Check the code switch settings on thereceiver.2. Use a pen or screw driver to set thecode switches on the back of the remotecontrol to match the code switches onthe back of the receiver.3. Once the code switches have been setpush the remote control button to activate your unit.HIGHNOR1 2 3 4 5 6 7 8 9 10 ON1 2 3 4 5 6 7 8 9 10 ONThe Remote Control BatteriesLocate the battery by sliding thebattery compartment cover.Dispose of old batteries properly.To prevent possible SERIOUS INJURY or DEATH:• NEVER allow small children near batteries.• If battery is swallowed, immediately notify doctor.WARNINGCAUTION WARNINGWARNINGNOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of thisreceiver and/or transmitter are prohibited, except for changing the code setting or replacing thebattery. THERE ARE NO OTHER USER SERVICEABLE PARTS.Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that may cause undesired operation.Contact us at www.chamberlain.com

Navigation menu