Centrica Hive HCI001 Hive Active User Manual pt 2

Centrica Connected home Limited Hive Active pt 2

Contents

User Manual pt 2

© 2017 Centrica Connected Home US Inc. 12 Greenway Plaza, Ste 250, Houston TX 77046. All rights reserved.© 2017 Centrica Connected Home Canada, Inc. Suite 1850, 10303 Jasper Avenue, Edmonton AB, T5J 3N6. All rights reserved.© 2017 de et importé par Centrica Connected Home Canada, Inc., Suite 1850, 10303 Jasper Avenue, Edmonton AB, T5J 3N6. Tous droits réservés.CGVIEW0917V1Hive ViewIC ComplianceThis device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:(1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.IC ComplianceLe present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation estautorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareildoit accepter tout brouillageradioélectrique subi, mêmesi le brouillage est susceptible d’en compromettre le fonctionnement.RF Exposure Information:This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC / by the RSS-102 is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. While there may be dierences between the SAR levels of various devices and at various positions, they all meet the government requirement.This product is compliance to FCC RF Exposure requirements and refers to FCC website:https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm Search for FCC ID: WJHHCI001This equipment should be installed and operated with minimum distance 5 mm between the radiator and . your body.
accordance with the instructions, may cause harmful interference to radio occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by • • Increase the separation between the equipment and receiver. • from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. (2412~2462 MHz) band. Ad Hoc function is supported but not able to operate on non-US frequencies:(i) The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;(ii) permitted for devices in the bands 5250-5350 MHz and 5470-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limit;(iii) e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated. Until further notice, devices subject to this MHz. This restriction is for the protection of Environment Canada’s RF Exposure Information:exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528. This equipment should be installed and operated with minimum distance 5 mm between the radiator and your body. This device and its antenna(s) antenna or transmitter.Informations sur l’exposition RF:d’exposition incontrôlées dans IC RSS-102 et a été testé conformément aux méthodes de mesure et aux procédures spécifiées dans IEEE 1528. Cet équipement devrait être installé et utilisé avec une distance minimale de 5 mm entre le radiateur Et votre corps. Cet appareil et son (ses) antenne (s) ne doivent pas être localisés ou fonctionner avec d’autres antennes ou transmetteurs.FCC ComplianceThis device complies with Part 15 of the FCC Rules. Operation is subject (1) this device may not cause harmful interference, and (2) interference that may cause undesired operation by the party responsible for compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the

Navigation menu