Cadi Scientific STG-836 SmartTAG User Manual STG836

Cadi Scientific Pte. Ltd. SmartTAG STG836

user manual

STG-836 Instruction Manual WARNINGS For customer in the U.S.A and Canada • You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. • This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. • Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device. • This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
• The lithium coin battery inside this product contains Perchlorate. The following statement is required by the State of California, USA: Perchlorate Material – special handling may apply. For customer in Europe • This equipment has been tested and found to comply with the limits set out in the R&TTE Directive. • Where you see this symbol on any of our electrical products/packaging in Europe, it means that at end of life the product/battery must be disposed of in accordance with any applicable laws or requirements for the separate disposal of electrical equipment/batteries. • The manufacturer of this product is CADI Scientific Pte Ltd, 31 Ubi Road 1, #03-00 Aztech Building, Singapore 408694. PRECAUTIONS  Keep batteries away from children.  Do not swallow batteries.  Do not throw batteries into water.  Do not throw batteries into fire.  Do not short-circuit batteries.  Do not recharge batteries.  Do not replace battery with incorrect. Incorrect type of battery replacement may cause risk of exposure.  Battery should be dispose according to the instructions SPECIFICATIONS 1 Power Power 3V DC, CR2032 Lithium coin cell 2 Dimension 33.9mmx30mmx12.8mm 3 Operating temperature 20°C - 50°C 4 Transmission frequency 868.4 MHz (For customer in Europe) 919.8 MHz (For customer in U.S.A) 925.0 MHz (For customer in U.S.A)
USAGE Switching on STG-836 • STG-836 will turn on automatically and start operating once the battery is inserted. Inserting battery 1. Turn over STG-836 and unscrew the 4 screws. 2. Lift the bottom cover away from the top cover.
3. Pull the battery out from the holder.
4. To replace a new battery, slide the battery into the battery holder from the position as shown on picture below. Make sure the positive side of battery is facing up. 5. Lastly, tighten the casings with the 4 screws Slide battery from this side Positive Side of battery facing -up

Navigation menu