COBAN Technologies WMICG4-CU Wireless Microphone System User Manual

COBAN Technologies, Inc. Wireless Microphone System Users Manual

Users Manual

COBANDSSS900MHzWirelessMicrophoneSystemforLawEnforcementOwner’sManual COBAN Technologies, Inc. 11375 West Sam Houston Parkway South Suite # 800 Houston, TX 77031 WWW.CobanTech.COm COBANWirelessMicrophoneSystemFeatures Frequency: 902 to 925 MHz ; DSSS; Frequency Hopping Range: 1000 ft (Line-of-Sight) Receiver Module: Dual Receivers with Dual Separated Independent Antennas RS-485 communicating to the Host 12 VDC/500mA Transmitter: 1650 mAH/3.7V Rechargeable Li-Ion Battery (Transmitter) 10 Hours Talk Time Built-in microphone with optional Lavaliere external Microphone Optional External Antenna for Extended Distance One On-Air Button with Two Programmable Buttons Weatherproof THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE CONDITION THAT THIS DEVICE DOES NOT CAUSE HARMFUL INTERFERENCE.
COBANTechnologies2COBANWirelessMicrophoneSystemOverview Wireless Microphone Transmitter Transmitter Top View Transmitter Side View Trasmitter Bottom View RecordButtonButton1ExternalAntennaMicButton2SyncContact
COBANTechnologies3 Wireless Microphone Receiver SyncContact1SyncContact2
COBANTechnologies4COBANWirelessMicrophoneSystemOperations1. Locatethecontactsatthebottomofthewirelessmic.2. Pressthewirelessmicrophonecontactsdirectlyontopofthereceiver’sregistercontacts.NOTE:Thereceiverislocatedbehindeachofthefrontseatsnearnearestthedoorpillar.3. Aconfirmationtonewillsoundtoindicatethereceiverandthemicrophonehavesynchronizedtheirfrequencies.4. Thewirelessmicrophoneisnowonstandbymodeandreadyforuse.NOTE:Syncingasecondmicrophonetothesamereceiverwillreplaceandnullifythefirstmicrophone.PatrolCarInstallationDiagramRecordbutton
COBANTechnologies5ThelargebuttonontheMicrophonewillalwaysbeusedtoinitiateRecording(Default:Frontonly)StatusIndicatorsProgrammableButtonFunctions1. Mute–ToggleAudioMute(doesnotaffectVideo)2. Stop–StopVideo(NotRecommended)3. Marker–Addsabookmarktothevideo4. AutoZoom–PerformsAutoZoomonfrontcamera5. PartnerAlert–NotifiesotherMicrophoneofemergency(doublemicrophoneunitsonly)6. Covertinterview–StartsRearSeatrecordingandblack‐outmonitorToggleCovertMode(Vibrateonly)1. PresstheRecordButtonandcenterProgramButtonsimultaneouslyfor2seconds.RepeatactiontoenableLEDandbuzzer(normal)mode.Action/Alert Regular mode (Audio, LED & Vibrate) Covert mode (Vibrate Only) Toggle between Regular and Covert modes - hold down REC and Button 1 for two seconds Vibrates and beeps once when active Vibrates twice when active Record Beeps and vibrates Twice GREEN LED (w/o lapel mic) BLUE LED (w/ lapel mic ) Vibrates twice Low Signal / Out of Range YELLOW LED Beeps intermittently Vibrates intermittently Stop recording – press Button 1 or Button 2 Long beep and vibrate once Long vibrate once Mute - press Button 1 or Button 2 GREEN LED BLINKS Beeps and vibrates in interval Button 2 – vibrate once Button 3 – vibrate twice Continues to vibrate once in interval time frames Other Programmable functions- press Button 1 or Button 2 Button 2 – beep once Button 3 – beep twice Button 2 – vibrate once Button 3 – vibrate twice Panic - hold down REC Button for 3 seconds. RED LED On - beeps and vibrates 3 times Off - beeps and vibrates once On - vibrates 3 times Off - vibrates once 
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure StatementThis equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Navigation menu