Bryton orporation DA1702 Bryton Smart Heart rate sensor User Manual QSG HR

Bryton Incorporation Bryton Smart Heart rate sensor QSG HR

Users Manual

CR2032+Rider oneRider 10Rider 100Rider 200/210Rider 310Rider 330Rider 520Rider 530Amis S430Amis S630OPENStrap Electrodes40Do Not BleachDo Not IronDo Not Dry CleanDo Not Tumble DryMade in ChinaBryton Smart HR SensorTo prolong the life of your heart rate monitor, detach the sensor and clean the strap after every use.Accuracy may be degraded by poor sensor contact, electrical interference, and receiver distance from transmitter.The Bryton Smart HR Sensor contains a user-replaceable CR2032 battery.
Bryton products and accessories are not medical devices and its readings are for reference only. Bryton is not responsibile for the consequences of any erroneous readings. Always consult your physician before beginning any training program or using a heart rate monitor. Please do not operate the product during any activities, because lack of proper attention may cause injury, death or material damage. When using or installing this product, please comply with all applicable local laws and regulation. We and our manufactuers and licensors shall not assume any responsibility for damages arising from using this product during activities, misuse, improper installation, act of God,any violation of traffic or safety regulations, or software or map data product therein. This product is not guaranteed to be free of errors or deficiencies, and is not guaranteed to be applicable for any defined purpose. FCC Regulations:§ 15.19 (a)(3)This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.§ 15.21Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.§ 15.105 (b)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.FCC RF Exposure ComplianceThis device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission for an uncontrolled environment.Industry Canada ComplianceIC Regulations:This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."CAN ICES-3(B)/NMB-3(B)This Category II radiocommunication device complies with Industry Canada Standard RSS-310. Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d’Industrie Canada. IMPORTANT NOTE:IC Radiation Exposure Statement:This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.CE Marking WarningThis is a Class B product, in a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Australian Consumer LawOur goods come with guarantees that can not be excluded under the New Zealand and Australian Consumer Laws. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.低功率電波輻射電機管理宣告本產品僅遵循中華民國國家通訊傳播委員會所頒佈低功率電波輻射性電機管理辦法規範，並經驗證通過合格，請使用者遵循相關電信法規以避免違反規定受罰。若使用者欲攜帶本機至其它國家應用，也請遵循該地區或國家之相關法令限制。根據交通部低功率電波輻射性電機管理辦法規定：第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率，加大功率或變更原設計之特性及功能。第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前功合法通信，依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。Limited Warranty Bryton Inc. warrants its products to be free from defects in materials or workmanship for one year from the date of purchase. Bryton Inc. will repair or replace any component that fails in normal use within this limited warranty period at no charge to the customer for parts or labor. This warranty does not apply to, 1) Damage caused by misuse, accident, abuse, fire, or other external causes or acts of nature 2) Physical damage to the surface, such as scratches and dents; 3) Consumable parts, such as batteries, heart rate belt, unless product damage has occurred due to a defect in materials or workmanship 4) Damage caused by anyone who is not an authorized service provider of Bryton Inc.Physical sizeWeightWater ResistanceTransmission rangeBattery lifeOperating temperatureRadio frequency / Protocol63 x 34.3 x 15 mm14 .5g (sensor) / 31.5g (strap)Incidental exposure to water of up to 1 meter for up to 30 minutes3 mUp to 2 years0 oC ~ 50 oC2.4GHZ/Bluetooth 4.0 and ANT+IMPORTANT: Please Read This Notice before Using This Product

Navigation menu