Blackroc Technology IP31356 RFID Tag Reader User Manual IP3 1356

Blackroc Technology Ltd RFID Tag Reader IP3 1356

User manual

IP3 1356Portable RFID ReaderRevision Date By CommentA17 Jan 2005 G A Price Original Issue
Page 1 of 6IP3 1356 Quick Start GuidePacking ListCheck to ensure that you receive these items:• Blackroc IP3 1356 Portable Reader (9005-0001) • Battery Pack (318-014-001)• IR Reflector For Colour 700 (075115-001)Setting up your 700 colour mobile computerInstall you Pocket PC application in accordance with the application instructions.Connecting the portable reader to the 700 series colourmobile computerNote: DO NOT remove the reflective tape from the inside of the portable reader. This reflectivetape aids in the communication of the IrDA signal between the portable reader and your mobilecomputer.Reflective tape, DO NOT REMOVE1. Slide your mobile computer into your portable reader.2. Ensure it slides in all the way. Your mobile computer communicates with the reader via theIrDA. Therefore, the IrDA signal passing from the portable reader must have a good IrDAacceptance on the side of the mobile computer. You will hear a click when you have the mobilecomputer completely inserted into the portable reader.
Page 2 of 6IP3 1356 Quick Start GuideMobile Computer fully engagedinto Portable Reader3. Attach two retaining screws. Ensure that they go straight into the mobile computer openings.Ensure retaining screws go straight into the slots on the mobile computer.4. Ensure that the colour 700 and the mobile reader are vertically aligned, so that an imaginaryvertical line would run through the centre of both units.
Page 3 of 6IP3 1356 Quick Start GuideRemoving the 700 colour mobile computer from portablereader5. Remove the two retaining screws.6. Grasp the 700 colour mobile computer at the display end, and simultaneously lift up (away fromthe reader), then pull forward.Portable reader LED location and explanation LEDs 1 to 5 (top to bottom)LED Name Description1 1 Application controllable LED 12 2 Application controllable LED 23IR TX Reader is transmitting Infrared data4IR RX Reader is receiving Infrared data5Battery Indicates remaining battery capacity; Green, more than 80% Orange, between 80 and 20% Red, less then 20%
Page 4 of 6IP3 1356 Quick Start GuideBattery installation and removalTo charge the battery contained in your portable reader, it is necessary to remove the battery fromthe handle and place it in the IP3U Dual Battery Pack Charger. This charging unit charges thebattery in four hours.1. To install the battery into the portable reader, insert the battery (tilt to fit into notch) into thecompartment opening and press in until the latch on the bottom of the battery snaps closed.The battery tab on the top of the battery pack fits into the notch in the compartment. Battery tab Battery latch2. To remove the battery pack, push the battery release latch forward and remove the batterypack from the handle. Battery release latch
Page 5 of 6IP3 1356 Quick Start GuideUsing the portable reader1. Charge battery for at least four hours before using for the first time.2. Inset the battery into the reader.3. After 5 seconds the battery indicator will settle and show the battery condition4. Use the reader in accordance with the software application.SpecificationsFrequency 13.56MHz.Output power 250mW.Communication Interface Infrared to Colour 700 series of mobile computers.Antenna Internal loop.Read range Dependant on tag size, environment and orientation but up to150mm to an ISO card size tag.Power Removable Lithium-Ion battery packTags supported ISO 15693, Texas Tag-it, Philips I-Code and Tagsys tags

Navigation menu