Binatone Electronics SH011 VerveLoop User Manual

Binatone Electronics International Ltd. VerveLoop

User Manual

Product ID: SH011Bluetooth ID: D033170FCC ID: VLJ-SH011IC: 4522A-SH011Short Short press for volume upLong press for next trackMusic Play/PauseAnswer/End CallsShort press for volume downLong press for previous trackprevious / next track Long press or double press during idle mode,then say the command组 装 示 意 图订单编号工厂型号版 本mm(1:1) 2016-11-16单 位客 户客户品牌客户型号日 期工程设计 业务审核SO201609026 说明书80G双胶纸 单色印刷 65*80MM 装钉77-007-00950BinatoneVerve LoopSH821M Motorola®1.0工程审核 批 准物料名称规格/材质描述物料编码封面封底 Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. Do not install this equipment in a conned or building-in space such as a book case or similar unit, and remain a well ventilation conditions at open site. The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. WARNING: The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, re or the like. No naked flame sources, such as lighted candles, should be placed on the apparatus. Attention should be drawn to environmental aspects of battery disposal. Use of the apparatus in moderate/tropical climates.Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCCRules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) thisdevice may not cause interference, and (2) this device must accept any interference, including interference that may cause undesiredoperation of the device.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation estautorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre lefonctionnement.o

Navigation menu