Belter Health Measurement and Analysis Technology EPA-13B4 Blood Pressure Meter User Manual ePA 46B

Shenzhen Belter Health Measurement and Analysis Technology Co., Ltd. Blood Pressure Meter ePA 46B

User manual

Edition: 1   󴌁ePA-13B4     Blood Pressure Meter     user manual
Edition: 2   shenzhen belter health measurement and analysis technology co.,ltd Thank you for purchasing the BELTER electronic Blood Pressure Meter This product is a sphygmomanometer which uses noninvasive method to measure human blood pressure.Please be sure to read the instructions before use.After reading, please safekeeping for inspection at any time, reference. Scope of application: used for blood pressure and pulse measurement of human body. (not suitable for Neonatal)  Important safety notes SIGNS AND SYMBOLS The following signs appear in this manual. READ THE SAFETY SECTION AND ALL INSTRUCTIONS AND WARNINGS COMPLETELY AND CAREFULLY BEFORE USING THIS PRODUCT. FOLLOW ALL SAFETY INSTRUCTIONS AND WARNINGS TO AVOID HAZARDOUS SITUATIONS AND TO MAKE CORRECT USE OF THIS PRODUCT. symbol Description  WARNING WARNING indicates a hazardous situation which, if not avoided, could Result in death or serious injury   CAUTION CAUTION indicates a hazardous situation which, if not avoided, may result in minor or moderate injury  NOTICE addresses practices not related to personal injury, such as product and/or property damage    Type BF               Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary  This item is compliant with Medical Device Directive 93/42/EEC of June 14,1993, a directive of the European Economic community     NOTICE
Edition: 3    Refer to instruction manual / booklet    Keep dry                Manufacturer           Authorized representative in the European Community           Date of manufacture            Serial number SYS systolic DIA diastolic PUL pulse  Bluetooth connection symbol  warning Do not use this product in the mixed gas of flammable gas with air or wih oxygen or with nitrous oxide conditions. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact you local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. The device is not suitable for use in the presence of flammable anesthetic mixtures with air or with oxygen or nitrous oxide. The device requires no calibration. The device is not repairable and contains no user serviceable parts. No modification of this equipment is allowed. Remove batteries if equipment is not likely to be used for some time.
Edition: 4  The user must check that the equipment functions safely and see that it is in proper working condition before being used. The manufacturer does not require such preventive inspections by other persons.  .  It  is  dangerous  to  carry  on  self  judgment  and  self  treatment  by  the  sufferer himself,so please follow doctor’s instruction. Self judgment may lead to exacerbation of disease .  Get a  serious  blood  circulation  obstacle,  blood paroxysm  sufferer,  please  use under the doctor's instruction, while measuring because the arm is squeezed may cause impatient internal bleeding . Infant and person not be able to express himself,please do not use . Please control the add pressue to the armband in the range of 300 mmHgs(40 kpas) , otherwise the arm may appear blood clot, benumbed symptom . This product is only used for human body blood pressure measurement and used outside  the  purpose  of  measuring  human  body  blood  pressure,  may  take  place accident . Please don't use a cell phone in the neighborhood of this product and have the danger to make product mistake action .  Please  don't  dismantle  to  unload  or  fix  by  yourself,  reformation  of  the  blood pressure account of essence or armband, otherwise can not measure correctly  Please use special arm band, otherwise may not be able to measure correctly. If and when  measuring pressure cannot stop or  abnormal exhaust abnormal situation, please press  the  "START/STOP", otherwise  you may  suffer from peripheral nerve disorder. If and when  measuring pressure cannot stop or  abnormal abnormal  gas exhaust, press the "START/STOP" no action, please manually release the arm belt. not suitable for use together with the HF surgical equipment Please avoid sharing with others, may cause skin allergies or cross infection    CAUTION   .Please be sure to use the appropriate cuffs band, otherwise you can't get correct measurement Please use according to the storage temperature and humidity standard recored in the user manual. When arrhythmia situation occurs,the measurement value may be incorrect or can not be measured. .This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
Edition:5 interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an uncontrolled environment.  .Please don't bump shot  or drop  the product, this may lead to the  measurement value of the product incorrect. When the plug or wire of the power adapter is damaged,please immediately drawn it out of the socket,otherwise may cause the danger of fire or electric shock. Please do not use wet hand to pull the power adapter from the socket,otherwise may cause electric shock or fire burn.     Operating instructions: NOTICE
Edition: 6   Using steps 1、Please charge the product performed before use 2、Please take off your coat    3、According to the product label "UP\DOWN", will be inserted in the arm cuff  4、Adjustment arm, make the product center position and heart at the same level Main body Display area  Arm belt Direction Function keys  charging interface
Edition: 7    5、Press start / stop button to start the measurement (SART/STOP) 6、The compression process is complete, the product will gradually reduce the pressure cuff, relax and keep still and not to talk 7、After the measurement is completed, the air arm belt will be automatically discharged, the measurement results will be displayed on the surface of the corresponding column   The initial use, please charge the battery, because the internal product factory charged amount and the storage time of products can lead to battery power consumed. If wear a thick coat, please take it off, in order to better measure Pay attention to dress more thick coat will cause a weak pulse, the measurement results of error Any  time to terminate  the  measurement, but  just  need  to  press  the start  / stop button(START/STOP), quick exhaust valve will quickly decrease with pressure in the arm Such as the continuous measurement, the interval time should exceed 10 minutes Such as the continuous measurement, the interval time should exceed 10 minutes regarding   the   effect   of   blood   flow   interference   and   resulting   harmful   injury   to   the PATIENT caused by continuous CUFF pressure due to connection tubing kinking;  too   frequent   measurements   can   cause   injury   to   the   PATIENT   due   to   blood  flow interference;  don’t place CUFF over a wound, as this can cause further injury;    NOTICE (Correct diagraph posture)
Edition: 8  don’t place CUFF    and    its    pressurization    on    any    limb    where intravascular   access   or   therapy,   or   an   arterio-venous   (A-V)   shunt,   is   present   because  of temporary interference to blood flow and could result in injury to the PATIENT; don’t place CUFF   and   its   pressurization   on   the   arm   on   the   side   of   a mastectomy; pressurization   of   the   CUFF   can   temporarily   cause   loss   of function of simultaneously used monitoring ME EQUIPMENT on the same limb; regarding   the   need   to   check   (for   example,   by   observation   of   the   limb   concerned)  that operation of the AUTOMATED   SPHYGMOMANOMETER does not result   in   prolonged impairment of the circulation of the blood of the PATIENT. adjustment of  the  pressure  reduction  rate, if  applicable, PATIENT position  in  NORMAL  USE, including  1)     comfortably seated 2)     legs uncrossed 3)     feet flat on the floor 4)     back and arm supported 5)     middle of the CUFF at the level of the right atrium of the heart –     a recommendation   that the PATIENT relax   as much   as possible   and not talk during the measurement PROCEDURE, –     a recommendation that 5 min should elapse before the first reading is taken;  How to select the adapter and use Please  choose  the  output  voltage is  DC5V,  output  current is  1A  dedicated  to  medical treatment power supply adapter. Please read the wiring in the annex to the insertion product and then connected to the power supply.                                The product is energized by "START/STOP" key prompt product " " flash, the charging is completed " " long light prompt   When charging products can not use If you use it out of the indicated temperature and humidity range,it may not be able to achieve claimed performance requirement.     NOTICE
Edition: 9  While measuring you must ensure the correct posture to obtain accurate results. Even  forget  to  turn  off  the  power  ,after  about  2  minutes  it  will  shutdown automatically . Please measure and control blood pressure at the same time every day. Measurement should be taken in quiet places ,the measured person should be in a relaxed sitting position. The product is energized by "START/STOP" key prompt product "8" flash, the charging is completed "8" long light prompt You'd better have a rest of 15 minutes before measurement. Adapters that are recommended in the instruction manual may cause fire or electric shock      data transfer The data uploads to cellular phone or computer via blue tooth. Key of symbols signal Warning-see user manual Treatment Err-1 Sensor abnormal Check whether there is no airbag gas discharged  Err-2 Blood pressure was not detected in heart or can't figure out Check  if  the dress  is too thick Err-3  Abnormal measurement results Keep body and arm stable and measure again
Edition: 10  Err-4 Cuff too  loose  or leakage (10 seconds pressure less than 30mmHg) Shut  down,  re-measure once. Err-5 trachea is blocked To  test whether  a hard object Err-6 High pressure fluctuation measurement Keep body and arm stable and measure again Err-7 Pressure exceeds the upper limit Please  check  arm  to  take whether already put like.  Battery energy shortage Please charge Excrescent check  Excrescent circumstance Reason Treatment Measured result is big deviation from normal Armband doesn't take correctly The exactitude ties up good arm to take talks or moves arm during the measuring Keep quiet and measure The clothes of curling up oppressed arm take off the clothes and measure again The  arm  takes  in  the  in  a short  time  to  carry  on exhaustion The  arm  takes  to  tie  up  too loosely   Please  tie  up  tight  arm  to take Add to ran over distance in suddenly the power failure reset clock Battery energy exhaustion Please charge After pressing button, don't show Battery energy exhaustion Give product charge Other phenomena Show the appearance trembles Please  press 【START/STOP 】button,
Edition: 11  Can not measure re-operate 1 time. Please charge the battery In addition still can not measure, please consult room contact with BELTER healthily    This  product  has  carried  on  check  in  the  factory,please  execute  strictly  in accordance with the instruction manual.   function specification Name Blood Pressure Meter Model number EPA-13B4 Display mode   LED Measurement scope The pressure measurement scope:0-295 mmHg DIA:25-245 mmHg  SYS:55-255 mmHg Pulse scope: 40-199 bpm Accuracy Pressure:±3 mm Hg Pulse accuracy :±5% Power DC5v/ Weight   265g Shape size   W70 mm*L155 mm*H74mm Arm band size: Arm belt500mm×130mm(Apply arm the scope22cm-36cm)  operating environment  a) temperature : +5℃-+40℃ b) relative humidity:15%-80% c) atmospheric pressure :700hpa-1060hpa Transportation and storage environment a)temperature :-20℃-+50℃ b)relative humidity:15%-90% c)atmospheric pressure :500hpa-1060hpa  Protection against electric shock internal electric source,.BF application part clinical allow maximum error margin This  product  pass  clinical  verification, the  clinical  maximum  allowable  error  is ≤±5mmHg/±0.67kPa Full power available time Such as a day to measure three times, about one week   NOTICE
Edition: 12  Lithium battery charge cycle life About 400 cycles product expects life span 3years  CLASSIFICATION 1. Internally powered equipment; 2. Type BF applied part: cuff;   3. IP22; 4. Not category AP / APG equipment; 5. Mode of operation: continuous operation.  Cleaning, maintenance and Storage Please always clean sphygmomanometer. Please use clean soft cloth ,gently wipe the LCD and shell, do not use solvents, and do not be soak it in water or other liquids. Please do not wash the arm band of the product. If the product is especially dirty you can use a soft cloth with water or neutral detergent, fully wring dry to wipe the product. Please do not use gasoline, thinner or similar solvent to clean arm band. When you do not use, please storage the sphygmomanometer and accessories in the collection bag. Please do not place the sphygmomanometer and arm band in high temperature, damp,   full of water vapor or direct sunlight conditions. Please do not let the blood pressure cuff suffer strong shock or vibration (e.g., fell on the ground). Please do not put the product in direct sunlight, high temperature, humidity, dust, corrosive gas many places to save, such as non-compliance will lead to product damage This product is not a toy, please do not play with the children and stored in children can not get the place, Storage of this product should be prevented from the damage caused by the pet and pest. Please do not dismantle the blood pressure. Please storage the product in requied environment. Calibration and repair This product has been calibrated and tested when delivered from the factory. If you have doubt about the measurement result of the product , please contact us and give the product to specialized person to repair Warranty: If you use the device according to the manual, replace it within 3 months and guarantee for free a year. The following situations are not included in warranty time: 1)  problem caused by self dismounting
Edition: 13  2)  problem caused by shocking during use or delivery. 3)  problem caused by incorrect maintenance 4)  problem caused by incorrect operating, problems caused by unprofessional repair.            Product Composition A piece of the product A copy of instruction for use   A charging connection wire Adverse events :non   ShenZhen Belter Health Measurement and Analysis Technology Co.,ltd 702/704, Block C, Tsinghua Unis Science Park, No.13 Langshan Rd, Hi-Tech  Industrial Park(north), Nanshan District, 518057 Shenzhen, People’s Republic of China  2018-03

Navigation menu