Behavior Tech Computer KB5209 Keyboard User Manual 5209e1

Behavior Tech Computer Corporation Keyboard 5209e1

users manual

55220099 KKEEYYBBOOAARRDD UUSSEERR''SS GGUUIIDDEEThis keyboard is fully compatible with IBM AT and PS/2.Keyboard Cable ConnectorAT Compatible Cable(5-pin Din Connector)Pin# Signal Name Voltage1Keyboard Clock +5VDC Signal2Ground 03Keyboard Data +5VDC Signal4Power Supply +5VDC5No ConnectionPS/2 Compatible Cable(6-pin Miniatures Din Connector)Pin# Signal Name Voltage1Keyboard Clock +5VDC Signal2Ground 03Keyboard Data +5VDC Signal4Reserved 05+5VDC +5VDC6Reserved 0The ACPI Power Management Keys and Their FunctionsSystem requirement:Ø Microsoft Windows 98 operating system.Ø The system supporting ACPI or APMII.Ø ATX motherboard and ATX power supply.The functions of the power management are specified and performed by Windows 98 operating system,no vendor-specified driver is needed to use them, but the Windows 98 operating system is necessary.There could be one or two or three ACPI power management keys on the keyboard, those functions areas follows.Power off key: Power down the system. Sleep key: Put the system to sleep.Wake up key: Wake up or powers up the system. Power key: (Single key with three functions above)Ø Press this key and hold over four seconds to power down the system.Ø Press this key and release it within four seconds to put the system to sleep.Ø When the system is asleep or powered down, press this key and release it within fourseconds to wake up or power up the system.
FCC GUIDELINESThis equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the useris encouraged to try to correct the interference by one or more of the following measures:♦ Reorient or relocate the receiving antenna♦ Increase the separation between the equipment and receiver♦ Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.♦ Consult the dealer or an experienced radio/TV technician for help.♦ Use only shielded cables to connect I/O devices to this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwo conditions: (1) This device may not cause harmful interference. (2) This device mustaccept any interference received, including interference that may cause undesiredoperation.Information to User:F Any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate thisequipment. Shielded interface cable, if any, must be used in order to complywith emission limits.IBM AT and PS/2 are registered trademarks of International Business Machines Corporation.Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries.All other trademarks are trademarks of their respective holders.3100504464Version 1.0November 1999Printed in China

Navigation menu