Ademco 8DL5815MN Security Door/Window Transmitter User Manual II with FCC statement

Honeywell International Inc. Security Door/Window Transmitter II with FCC statement

II with FCC statement

K0017 4/16/02ADEMCO No. 5815MNContact TransmitterPreliminary Installation InstructionsUse the 5815MN shock sensor only with alarm systems that support 5800 series wireless devices. Thetransmitter has its own unique serial number permanently assigned during manufacture, which must beentered into the control panel prior to the transmitter’s usage. Refer to the control unit’s installationinstruction for programming details.Note: During programming of the control unit, 5815MN transmitters should be treated as “RF” (i.e.supervised RF) Type. The 5815MN is assigned as one zone.MountingBefore mounting the transmitter permanently, conduct Go/No Go tests (see control’s instructions) to verifyadequate signal strength from the mounting location.1) Learn serial number as described in the control panel installation instructions. To cause the sensorto transmit, fault and restore the magnetic contact.2) Determine mounting location.3) Verify range by holding the sensor in the approximate mounting location and faulting themagnetic contact. The panel (in test mode) should respond to the transmissions. If not, find a moresuitable mounting location.4) Mount the transmitter and magnet with the appropriate mounting hardware.5) Verify operation by faulting and restoring the magnetic contact – check for trip at alarm panel.SpecificationsContact Gap:1/2 inch minimumUnit Dimensions:1.6” (40.64mm) x 1.6” (40.64mm) x 0.8” (20.32mm)Battery:Panasonic CR2, Sanyo CR2, and Duracell DLCR2.ADEMCOGROUP165 Eileen Way, Syosset NY 11791Copyright© 2002 Pittway CorporationRefer to the installation instructions for the receiver/control with which this device is used for warrantyinformation, and details regarding the limitations of the entire alarm system.FCC StatementFCC ID: CFS8DL5815MNThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation.

Navigation menu