Ademco 8DL5811 Security Transmitter User Manual 800 03928 5811 A1

Honeywell International Inc. Security Transmitter 800 03928 5811 A1

Contents

Manual

800-03928 2/09 Rev. A ADEMCO 5811 One Zone Door/Window Transmitter Installation Instructions Model 5811 is a single zone Door/Window Transmitter, compatible with alarm systems that support 5800 series wireless devices. 5811 has a unique serial number permanently assigned during manufacture, which must be entered into the control panel upon installation. Refer to the panel’s installation instructions for programming details. Note: During programming of the control unit, 5811 transmitters should be treated as “RF” (i.e. supervised RF) Type (mandatory for UL installations). MOUNTING Choose a mounting location for 5811 where the device is stationary and the magnet is mounted to the moving part of the door or window. Before mounting 5800 permanently, conduct Go/No Go tests (see control’s instructions) to verify adequate signal strength from the mounting location. 1. Mount using double-faced tape (supplied) by affixing it to the back of the unit and mounting the unit in place. Use screws (optional) if desired. Warning: Do not mount unit in a location where temperature may approach the freezing point (32°F / 0°C). 2. Mount the magnet (supplied) near the alignment marks on the case (see Diagram). BATTERY REPLACEMENT 1. Open housing by inserting a flat blade screwdriver into latch and twisting gently. 2. Remove old battery cell. 3. Observe proper polarity (see diagram) then insert new battery so it is held by plastic retaining clip. 4. Engage the case tabs (see diagram), then rotate the housing to close. Engage latch with firm pressure. REEDLATCHMOUNT 5811 TO STATIONARY SURFACEROTATETOCLOSEMOUNT MAGNET TO MOVEABLE SURFACEMOUNTINGHOLESCASE TABS FEDERAL COMMUNICATIONS COMMISSION STATEMENTS: The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment. FCC / IC STATEMENT: This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. SPECIFICATIONS Dimensions 2-1/8” (55mm) x 1-3/16” (30mm) x 1/4” (7mm) Replacement Battery Renata/Sanyo/Panasonic CR2032 WARRANTY INFORMATION For the latest warranty information, please visit: www.honeywell.com/security/hsc/resources/wa REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM. 2 Corporate Center Drive, Suite 100P.O. Box 9040, Melville, NY 11747Copyright © 2008 Honeywell International Inc.www.honeywell.com/security Ê800-03928^Š 800-03928 2/09 Rev. A

Navigation menu