Acrox Technologies LOWIRTMU01 2.4G NANO MOUSE User Manual GA4 MRT Users Guide 20081216

Acrox Technologies Co., Ltd. 2.4G NANO MOUSE GA4 MRT Users Guide 20081216

Users Manual

Safety Notice1 This product complies with IEC 60825-1, class 1 laser product. 2 Your product complies with FCC and CE rules. 3 This product has no serviceable parts. Use of controls or adjustments of procedures other than the user guide may result in danger. 2.4GHz Wireless Optical Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installation Please DO NOT direct the laser beam at anyone’s eye.
1Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
2 Functional Introduction Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Pull AAA Battery 1’st 2’ndNano ReceiverScrolling Wheel & Low Battery / Pairing indicator Left button Connect Button Right button Battery Cover
3 Nano Receiver Setup the Connection between the Receiver and the Mouse 1. Plug the Nano receiver into the USB port of your computer. 2. Insert the batteries into the mouse, then follow the steps below. 3. If the mouse is not working, please put it into pairing mode. 4. Pairing: Re-plug the Nano receiver into the USB port of your computer. If the mouse does not work after 10 seconds, then press the connect buttons on the mouse again. (Nano receiver has auto pairing Take outPush
4function). 5.The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. The mouse remains off afterwards. 6. When the battery is low, the Low Power indicator blinking. During pairing Green LED Blinking 10 Sec. Connected NG Green LED Off Red LED Blinking Low Battery Red LED on 10 Sec. Power On Scrolling Wheel & Low Battery / Pairing indicator Connected OK

Navigation menu