Acrox Technologies KB33 AmazonBasics Wireless Keyboard User Manual

Acrox Technologies Co., Ltd. AmazonBasics Wireless Keyboard

User Manual

   AmazonBasics Wireless Keyboard and Mouse Combo w/Nano Receiver  USER'S GUIDE Ver.:1.00                     CAUTION: To use this product properly, please read the user's guide before installation
 1Federal Communication Commission Interference Statement  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.   However, there is no guarantee that interference will not occur in a particular installation.    If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  -  Reorient or relocate the receiving antenna. -  Increase the separation between the equipment and receiver. -  Connect the equipment into an outlet on a circuit different from                       that to which the receiver is connected. -  Consult the dealer or an experienced radio/TV technician for help.  FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
 2Functional Introduction             Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. Step 4: Turn on power switch.            **Warning: *Please insert the battery with the correct position according to the instruction       labeled on the mouse. AAA Battery Left button Right button Battery Cover Scrolling Wheel  Connect  Button  ON/OFF Switch Nano Receiver LED Indicator Pull 1st 2nd
 3Step 5: If you need to travel with your wireless mouse, made sure you   turn off the POWER SWITCH.   Keyboard Buttons                         Key Function (* compound key, Press with Fn key) 1   Media Player on  Turn on the Media player program 2   Volume down (Voice-)  Decrease the computer's sound   volume. AAA battery X 2
 43   Volume up (Voice+)  Increase the computer's sound volume.4   Mute  Mute (turns off) the computer's sound 5   Previous  Switch to the previous media track 6   Next  Switch to the next media track 7   Play/Pause  Switch between playing and pausing media 8   Stop(Media)  Stop playing the media in the media player 9   Homepage(www/e)  Start the default Web browser and loads the home Web page 10  Outlook(E-mail)Default  Start the default e-mail program 11   My Computer  My Computer 12  My Favorites  Open My favorite after into Internet browser application 13  LED indicator  Caps Lock 14  LED indicator  Number Lock 15  LED indicator  Low Battery & Pairing Indicator 16 Connect Button  17 Battery Cover     Encrypted air-protocol with AES 128 AES (Advance Encryption Standard) is a specification for the encryption of electronic data.
 5Setup the Connection between the Receiver and the Mouse, Keyboard. 1. Insert the batteries into the mouse & Keyboard, then follow the steps   below.  2. In the meantime, to open the mouse under the cover, take the nano     receiver out.           3. Plug the Nano receiver into the USB port on your computer.        4. If the mouse or keyboard does not work, please put them into pairing     mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then   press connect button of the mouse and keyboard. If the mouse or   keyboard does not work after 10 seconds, pair them again. (The       receiver has auto pairing function). 6. The LED indicator on the mouse & Keyboard flashes steadily when it   is in pairing mode and stops blinking when it is successfully paired   with the receiver.
 67. When low battery, the battery indicator on the keyboard or the mouse   will start to blink.                          LED indicator  *Keyboard IndicatorLED Blinks for 10 sec. Low Battery Warning   LED is on for 10 sec.   Power ON LED Blinking Pairing (LED OFF when paired or   failed after 10 sec.) LED Indicator  *Mouse IndicatorLED Blinks for 10 sec. During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec. Low Battery Warning
 7  FCC Warning  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  NOTE: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.   IC WARNING  This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.  Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Navigation menu