ARCHETYPE SNL Pathlights User Manual PathLights Catalog 2012

ARCHETYPE LTD. Pathlights PathLights Catalog 2012

user manual

With the new easy-to-install PathLights lighting system, your path will automatically light up under low-light conditions. Using our Instant Lit technology, “A” light units alert “B” light units to turn on immediately lighting your way with a warm glow that brightens your path. The lights remain on for approximately one minute, giving you the time you need to walk up or down stairs or a dark hallway, and then turn off automatically. Nothing could be simpler.PathLights can be mounted onto any wall surface using the included double-stick tape or screws. It takes less than 5 minutes to install the three lights in this package. For interior use only.How do PathLights work?Where can I put my PathLights?PathLights are designed to work only under low-light conditions - they do not turn on unless it’s dark.The UNITS sense the light level in the room. Motion detection is only activated when it’s dark. Motion detecting UNITS activate UNITS within 18 feet of the UNITS and automatically lights your way. StaircasesHallwaysPathLights work under low-light conditions only.The 3 PathLights functionas a system - not designedto work as individual units.PathLights stay on for about one-minute and then turn off automatically.Distributed byShort Hills, NJARCHETYPEPatent PendingAll Rights ReservedMade in China™1Find the 3 plastic mounting plates (backof units) in the package. Determine where you want to place your PathLights. Refer to “Where can I put my PathLights?” aboveas a guide.2Attach the mounting plates to the wall - about 8 inches to 10 inches from the floor - using either the enclosed screws or the attached double-stick tape. Make sure that the mounting plate is oriented correctly -- the words “LEVEL LINE” on the mounting plate should be horizontal and readable.34Rotate each unit clockwise onto amounting plate until it comes to a stop. Your Pathlights are ready for use.Questions? Call us at 1-866-797-6686LEVEL LINEMounting PathLights to the Wall8”-10” from floor/stepto bottom of PathLightInsert 3 “AA” batteries into each unit as indicated in battery compartment.
FCC Statement: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Modifications to this product will void the user’s authority to operate this equipment.

Navigation menu