ADC Telecommunications PSM25TDH Prism 20W 2.5GHz TDD SISO High HDM User Manual FWPP 504 01

ADC Telecommunications Inc Prism 20W 2.5GHz TDD SISO High HDM FWPP 504 01

Contents

User manual II

FWPP-501-01 Issue 1 • 320000117795 Rev A FlexWave Prism Remote Unit and HDM RF Module Installation Guide© March 2016 CommScope, Inc. Page 61Install the Prism Remote UnitOption B: Fiber Pass-Through ConnectorNOTE: Use the following procedure to install the fiber cables using a Fiber Pass-Through Connector. • If the PRU that you are installing has a Hardened Multi-Fiber Optic Connector, follow the procedure in "Option A: Hardened Multi-Fiber Optic Connector” on page 55• If the PRU that you are installing has a legacy ProAx Connector, follow the procedure in "Option C: ProAx Connector (Legacy AC-Powered PRUs)” on page 65.NOTE: The graphic shown in this procedure depict an AC-powered PRU. However, the Fiber 1 and Fiber 2 connectors on a DC-powered PRU are in the same location and use the same procedure as the AC-powered PRU to install fiber cables using a Fiber Pass-Through Connector.UsethefollowingproceduretoinstallthefibercablesusingtheProAxconnector:1ObtainanenvironmentallyhardenedfibercableterminatedwithLCconnectors.Theoutsidediameterofthecablejacketmustbebetween.035”and.63”.2Completetheinstallationstepsin"UnpackandInspectthePrismRemoteUnitandComponents”onpage39through"ConnectaNetworkCabletothePRUChassis”onpage53.3RemoveconnectorplugonlyfromtheFiber1connector,unlessmultiplefibercablesareneeded.NOTE: Do not remove the dust cover from the Fiber 2 connector until directed to do so. Connectorplugs

Navigation menu